Experience:

Full competition licenses with SCCA & Midwestern Sports Car Club

Personally have built two complete Mazda race cars from ground up (SCCA Spec Miata & F-Production). This includes all mechanical work, car maintenance, engineering/development, & car setup. A few of the major fully developed systems include:

Bodywork (Composite Molds)

• • • One piece carbon fiber hood

    • Wind screen (replaces the original windshield)

Suspension Design

• • • Adjustable front upper control arms utilizing rod ends

Engine Assembly

• • • Complete engine inspection and rebuild

Cooling System

• • • Radiator Sizing

    • Plumbing

    • Duct Work

Electrical System

• • • Sensors

    • Harnesses

    • Ignition Systems

    • Tuning

    • Data Acquisition

Tuning/Setup

• • • Data Acquisition and Analysis

    • Ride Height

    • Wheel Alignment

    • Camber/Caster

    • Scaling & Corner weights

Support a SCCA GT1 / Trans-Am car for the SCCA Central Division & National Championship with occasional races in pro SCCA Trans-am races. Duties include:

• Mechanical Maintenance (Change engines, transmissions, rear end assemblies, part inspection, repair, improvements)

• Engineering (Parts, systems, applied universally to all aspects)

• Car Setup (Full shop setup and advise setup changes trackside to improve handling characteristics)

• Data Analysis (Utilize AIM & Motec software to monitor and assist with car data)

• Race Preparation 

• Race Engineer

Competed in 100cc & 125cc shifter kart Racing

• • Badger Kart Club Points Series

  • Rock Island Grand Prix

  • Road America Motoplex